Installation
Adjustment system - Installation Instructions
Page 27
Figure 12 SMS-B-45x90: Examples of connecting the lifting element to the base frame by means of
standard connection bracket (small/large)
Make sure that the electrical lines of each leg of the workplace can be laid without putting
them under tension by maintaining the permissible bending radius of 57 mm (single) and 86
mm (multiple). The electrical wires to the lifting elements are each 2.5 m long.
Screw the leveling feet (Optional) fully into the lifting elements.
Position the workplace properly again such that the leveling feet stand on the floor.
IMPORTANT
Take care to ensure that the workplace is not put down too abruptly in order to
avoid damaging the lifting elements.
