QUICK INSTALLATION GUIDE
Bullet Network Camera
Hardware Installation
Accessories
Product DVD x1 (including manuals)
●
Anchors and Mounting Screws x3
●
Camera Bracket x1
●
RoHs Compliance x1
●
(Optional) Power Adapter
●
Quick Installation Guide x1
●
© by Surveon Technology, Inc. All rights reserved.
P
hillips Screwdriver
Tools Required
Warning!
Only qualified service personnel should install and service this
product in order to avoid risk of injury from electrical shock and
energy hazard.
Observe all ESD (Electro-static Discharge) procedures during
installation to avoid damage to the camera and its components.
User-provided Items
●
LAN Cable
●
PC with Windows (XP or above) and web
browsers (Internet Explorer 6.0 or above)
installed
●
●
Electric Drill
QMC 3 3 5 1 A E R 1 2
4. Connect the camera to the network with the network connector.
5.
onnect the power connector to the power adapter, and then
connect the adapter to a power outlet.
6. Check if the live view displays normally after the camera is logged in. Please refer to
Logging to the System
Section on p2 for more details.
PoE (802.3af ) is supported. You can also c
Installation
2
1. Use the camera bracket to mark the desired camera position on a flat interface.
Make one cable entry hole and three screw holes on the surface with the electric
drill.
2. Fix the camera bracket on the surface with screws and screw anchors.
3. Join the camera with the bracket.
The bracket is suggested to be tightened after positioning the camera to ensure the waterproof
characteristics of the camera are maintained.
1
1
1
1
Before You Start
4
Please prepare a PC with Windows (XP or above) and web browsers (Internet Explorer 6.0 or above)
installed.
Camera Deployment
3
1
1
Hardware Overview
Front View
3
2
1
2
1
Note:
The power connector is provided for the solutions without PoE.
5
Appendix: Resetting the Camera with the Reset Cable
To reset the device to the factory default settings:
1. Make sure the device is in operation mode.
2. Poke the little hole on the reset cable cover or press and hold the red button with a needle after
removing the cable cover until the camera restarts (about 2 seconds). The status LED will change to
amber during startup.
3. When the status indicator changes back to green (which may take up to 1 minute), the process is
complete. The default IP address is 192.168.88.10 if not assigned by a DHCP server.
4
6
5
1
IR
LED
2
Lens
3
Light
Sensor
4
Power Connector
5
6
Network Connector
Reset Cable
Note:
(1)
Resetting to the factory default settings using the reset cable will cause all parameters
(including IP address) to be reset. To reset the unit without changing parameters, disconnect
and reconnect the power connector. (2) Camera resets can also be performed under
System
> Reset To Factory Default
on the web interface.