SureCall GuardianA, Руководство пользователя и инструкция по установке

Страница: 21 / 36

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | support@surecall.com
21
5.2 DIP Switch Configuration
By default, all DIP switches are turned in the OFF position, which provides maximum gain to all channels.
To access digital channelization, see "Chapter 7: Sentry Configuration & Monitoring" on page 24. Note that attenuation
made through Sentry software is cumulative with that of the Booster’s DIP switches.
BEFORE INITIAL CONFIGURATION, set booster switches with high, but not full, attenuation (as full attenuation would cause
the band to shut off).
DURING CONFIGURATION, you may add gain incrementally until the signal level has improved enough to meet safety
requirements.
Note that red flashing lights indicate the system has detected oscillation for the corresponding channel(s). The band will turn
off if adjustments are not made. When adjusting booster attenuation, full power is not always the best option. The goal is to
obtain a signal level throughout the building that meets safety requirements.
Configuration and Testing
The following diagrams and notes explain how to interpret, and use, these switch banks.
DIP switch organization
PS 700 DL DIP switches
control 700 band downlink PS UL DIP switches control
700 band and 800 band
uplink PS 800 DL DIP switches
control 800 band downlink
NOTE:
TURN ALL UPLINK DIP SWITCHES TO
ON
AND ADJUST THEM
BACK ONE STEP AT A TIME UNTIL UPLINK CONNECTIVITY IS MADE
WITH THE EMERGENCY RADIO TOWER.
ATTENUATION THROUGH SENTRY SOFTWARE IS CUMULATIVE
WITH THAT OF THE BOOSTER’S DIP SWITCHES.