INSTALLATION
SureCall Dual Force
Cellphone-Mate, Inc.
Page 8
All rights reserved.
3.
Hand tighten the connection.
Step 3. Mount the Booster (Optional)
1.
Select a location for your booster.
2.
Attach the supplied mounting kit to the booster using the supplied screws.
Tighten the screws with a screwdriver until snug, then add a ¼-to-1/2 turn. Do
not over tighten.
3.
Orient the signal booster so the LEDs and DIP switches face away from the
wall and the LEDs are seen easily. Then mount the signal booster to the wall
using appropriate screws and/or wall anchors.
4.
Connect the outdoor antenna cable to the
Outdoor Antenna
port on the
booster.
5.
Connect the indoor antenna cable to the
Indoor Antenna
port on the booster.
6.
Verify that all cable connections are snug, and that the outdoor and indoor
antennas are connected to the proper jacks.
Step 4. Connect to AC Power
1.
Connect the AC power cord to the booster (see page 4).
2.
Connect the plug on the other end to a 110V AC power outlet. Be sure all
connections to the booster are tight and secure.
x
The booster turns on automatically.
x
The
Power
LED goes ON to show that the booster is ready for use (see
page 4).
x
The
Alert
LEDs flash up to 15 seconds on each band to show the band is
activated (see page 4).
The booster is rated for 5-20V input voltage. DO NOT use the booster with a
higher voltage power supply. This can damage the booster and/or cause
personal injury.