Sur-Gard SG-System III, Руководство по эксплуатации

Страница: 31 / 131

CHAPTER FOUR - PROGRAMMING/OPERATION
28
SG-Sys
tem I Operating Man
ual
4
Figure 4-3
12 Linecard(s) (Shelf 1) 12 Linecard(s) (Shelf 1)
15 Linecard(s) (Shelf 2) 15 Linecard(s) (Shelf 2)
Automation IP: 30.0.25.6 Automation IP: 30.0.25.6
Console IP: 30.0.25.26 Console IP: 30.0.25.26
Printer IP: 30.0.25.26 Printer IP: 30.0.25.26
SG-SYSTEM III v2.00.01.019 (Shelf 1) SG-SYSTEM III v2.00.01.019 (Shelf 1)
SG-TCP SG-TCP
ACTIVE
IP: 30.0.21.112 IP: 30.0.21.112
Dec-15-2010 10:32:38 Dec-15-2010 10:32:38
SYSTEM OK
DG009578
SUR-GARD
Change Accept Change Accept
Enter Password Enter Password
User: User: 0
Password: **** Password: ****
The Configuration mode allows programming of the various features and options available on the SG-System III. To enter the Configuration
mode, press the [Enter] button.
Choose user 0 and enter the Master Access Code using the buttons; the default Master Access Code is "CAFE".
When the access code is entered, the screen will display the Configuration Menu.
CPM3 Options allow the user to customize the operation of the system TCP/IP addressing, Passwords, COM settings and other system
functions. Refer to the description of all CPM3 options and their default settings.
System Functions
Reset the SG-CPM3

Restarts the SG-CPM3. This is required to make the changes to some options effective. For example, the IP address.
Date and Time

Sets the date and time of the SG-System III. This can also be done from the SG-Systems Console software.
System Information
Lists information such as CPM3 version, product ID, and MAC address.
Cold Boot Line Card
A cold boot will set the line card back to factory default settings.
Visual Indicator Test
When selected, the SG-CPM3 will activate all front user interface enunciators and buzzers for 5 seconds. All LEDs will activate and all pix-
els on the LCD will activate (display turns white) for this duration. Any outputs set for Buzzer Follow or Trouble Output activate during this
test.
NOTE: Visual Indicator test should not be performed while other functions are active (such as line test/AHS
Flash).
SG-CPM3 Options
NOTE: The following defaults are for the Primary SG-CPM3.

A Secondary SG-CPM3 will have the following MASK set to ON [1C, 1D, 20, 21, 22, 23, 25, and 27] at default ,
the remainder will be set to OFF. This is to reflect a full redundant system.

All references to OFF = option value of 00, and ON = option value of 01.
Option 01: IP Address
Default (10.0.7.100)
This section is the IP address of the SG-CPM3. The IP Address will be entered as a dotted decimal number. Example: 192.168.002.045.
Each segment of the IP address shall have a valid range from 000 to 255.
NOTE: For changes to this program option a reset of the unit is required before the new parameters are used.
Option 02: Subnet Mask
Default (255.255.0.0)
This section is the subnet mask of the SG-CPM3. The subnet mask will be entered as a dotted decimal number. Example: 255.255.000.000.
Each segment of the subnet mask shall have a valid range from 000 to 255.