Sur-Gard SG-System III, Руководство по эксплуатации

Страница: 29 / 131

CHAPTER FOUR - PROGRAMMING/OPERATION
26
SG-Sys
tem I Operating Man
ual
4
Introduction
The SG-System III can be programmed manually using the front panel; from a local computer or remotely using the TCP/IP network and
SG-Systems Console software. The Debug output is intended as a testing and troubleshooting tool. Manual programming allows the user to
program all of the SG-System III options for remote and local operation. Manual programming does not support the grouping of line cards
into hunt groups or line pools.
Console Software
The Console software is intended to be the primary method of programming the system. Refer to the SG-Systems Console Manual for
details.
Debug
The debug output is another method of accessing the line card's programmed options and diagnostics features. A debug cable is required to
connect by serial communication from the line card to a standard PC running Windows 95 or higher software.
NOTES:

DRL3E/DRL3E-2L/DRL3-2L - Profiles 1-63 cannot be set through debug

DRL3 - If the line card reboots, changes made with set option through debug are lost. To make changes per-
manent, use the Write option.

ALL PROGRAMMING WITH THE DEBUG SETUP IS LOST WHEN THE SYSTEM IS POWERED DOWN OR WHEN
LINE CARDS ARE REBOOTED OR REMOVED FROM THE RACK.
Debug Cable Connectivity
• Connect the RJ-45 end of the debug cable to the debug jack on the front of the line card.
• Connect the female DB-9 connector to the serial port of a computer. For debug cable pinouts. refer to figure 1-5.
Debug Setup
• Using Windows 95 or higher, point and click on the button.
• Select Programs

Accessories

Communications

HyperTerminal .
• A connection description window is displayed with a prompt on the 'Name' category. Type a name. Point and click on the 'OK' button.
• A phone number window is displayed. Choose the COM port required for connection and point and click on 'OK'.
NOTE: The SG-Systems Console may also be used allowing for PC's that do not have access to HyperTermi-
nal to be able to program options and perform "logger functions". Refer to the SG-Systems console manual
for setup instructions.
Figure 4-1