SUPREME 32IN, Руководство пользователя

Страница: 10 / 29

10
2.13 Circulating Chamber
The circulating chamber is a standard component of the FLAIR insert. It is
designed to prevent heat escaping to the existing chimney and allows for an
optimal flow and heat transfer. The top removable bracket can be taken off during
installation to allow for better accessibility to the liner adaptor. Note that the top
removable bracket needs to be installed and fastened (2 wing nuts) before
operating the FLAIR.
2.14 Adjustable Legs
The FLAIR insert comes with three adjustable legs in the bottom of its firebox to
allow adjustment of the height for leveling purposes.
2.15 Liner Adaptor
The Liner Adaptor is a component that comes with the FLAIR and is required to
connect a 6
” stainless steel liner to the unit.
2.16 Metal Tag
The Metal Tag specifies that alterations have been made to the masonry
fireplace to accommodate the FLAIR insert. The metal sheet having the Metal
Tag is to be installed with two screws at the hearth of the masonry fireplace.
Note that the Metal Tag must be installed with the writing face upwards so
that it is visible if the insert fireplace is removed.
The Metal Tag reads as follows:
This fireplace has been altered to accommodate a fireplace insert and should
be inspected by a qualified person prior to re-use as a conventional fireplace.
Ce foyer a été modifié afin d'y insérer un foyer encastrable et doit être inspecté par une personne qualifiée avant
sa réutilisation comme foyer conventionnel.
2.17 Serial Number
The certification label contains important information regarding the
installation and operation of the FLAIR fireplace insert. In addition,
the serial number of the unit is permanently embossed onto the top
right corner of the label. The certification label is located at the
bottom right corner of the door and is accessible by opening the
door and pulling the plate.
Figure 2-8: Liner Adaptor
Figure 2-7: Circulating Chamber
Figure 2-9: Serial Number Location