- 9 -
1.3.2
W
ORKING TABLE SIZE AND DRILLING HOLE REQUIREMENT
The figure below shows the location of the edger on the workbench and where drilling is
required. Place the machine well before drilling to determine the position!
Attention
：
> Refer to the given dimensions
；
>>length
：
705mm
；
>>width
：
465mm
；
>>diameter of the drainage
：
100mm
；
>>distance of the drainage hole center to the right side of the machine
：
356mm
；
>>distance of the drainage hole center to the front side of the machine
：
190mm
；
> Make enough space around the edger.
> Make sure the workbench is stable and smooth.
> Installation should be far away from the heat source.
diameter of the drainage
：
100mm
190mm
length
：
705mm
width
：
465mm
356mm
