Supero AS-4041M-82R, Руководство пользователя

Страница: 99 / 106

B-5
Appendix B: BIOS POST Checkpoint Codes
Checkpoint Code Description
4Ch The memory below 1 MB has been cleared via a soft reset. Clearing the memory
above 1 MB next.
4Dh The memory above 1 MB has been cleared via a soft reset. Saving the memory size
next. Going to checkpoint 52h next.
4Eh The memory test started, but not as the result of a soft reset. Displaying the fi rst
64 KB memory size next.
4Fh The memory size display has started. The display is updated during the memory
test. Performing the sequential and random memory test next.
50h The memory below 1 MB has been tested and initialized. Adjusting the displayed
memory size for relocation and shadowing next.
51h The memory size display was adjusted for relocation and shadowing.
52h The memory above 1 MB has been tested and initialized. Saving the memory size
information next.
53h The memory size information and the CPU registers are saved. Entering real mode
next.
54h Shutdown was successful. The CPU is in real mode. Disabling the Gate A20 line,
parity, and the NMI next.
57h The A20 address line, parity, and the NMI are disabled. Adjusting the memory size
depending on relocation and shadowing next.
58h The memory size was adjusted for relocation and shadowing. Clearing the Hit
<DEL> message next.
59h The Hit <DEL> message is cleared. The <WAIT...> message is displayed. Starting
the DMA and interrupt controller test next.
60h The DMA page register test passed. Performing the DMA Controller 1 base register
test next.
62h The DMA controller 1 base register test passed. Performing the DMA controller 2
base register test next.
65h The DMA controller 2 base register test passed. Programming DMA controllers 1
and 2 next.
66h Completed programming DMA controllers 1 and 2. Initializing the 8259 interrupt
controller next.
67h Completed 8259 interrupt controller initialization.
7Fh Extended NMI source enabling is in progress.
80h The keyboard test has started. Clearing the output buffer and checking for stuck
keys. Issuing the keyboard reset command next.
81h A keyboard reset error or stuck key was found. Issuing the keyboard controller
interface test command next.
82h The keyboard controller interface test completed. Writing the command byte and
initializing the circular buffer next.
83h The command byte was written and global data initialization has completed. Check-
ing for a locked key next.
84h Locked key checking is over. Checking for a memory size mismatch with CMOS
RAM data next.
85h The memory size check is done. Displaying a soft error and checking for a password
or bypassing WINBIOS Setup next.