Supero 1017C-TF, Руководство пользователя

Страница: 64 / 96

6-6
S
UPER
S
ERVER 1017C-TF Manual
Insert a drive into the carrier with the PCB side facing down and the connec- 2.
tor end toward the rear of the carrier.
Align the drive in the carrier so that the screw holes of both line up. Note that 3.
there are holes in the carrier marked "SAS" or “SATA” to aid in correct instal-
lation.
Secure the drive to the carrier with four screws as illustrated below. 4.
Insert the drive carrier into its bay, keeping the carrier oriented so that the 5.
hard drive is on the top of the carrier and the release button is on the right
side. When the carrier reaches the rear of the bay, the release handle will
retract.
Push the handle in until it clicks into its locked position 6.
Removing a Hard Drive (Figure 6-4)
To remove a carrier, push the release button located beside the drive LEDs. 1.
Swing the handle fully out and use it to pull the unit straight out (see Figure 2.
6-5).
Note: Your operating system must have RAID support to enable the hot-plug ca-
pability of the hard drives.
Figure 6-4: Installing a Hard Drive into a Carrier
!
Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the
Supermicro Web site at http://www.supermicro.com/products/nfo/storage.
cfm