Supermicro SuperServer SYS-210TP-HPTR, Руководство пользователя

Страница: 105 / 153

105
Chapter 7: Troubleshooting and Support
7.7 CMOS Clear
JBT1 is used to clear CMOS, which will also clear any passwords. Instead of pins, this jumper
consists of contact pads to prevent accidentally clearing the contents of CMOS.
To Clear CMOS
1. First power down the node completely.
2. Remove the node to access the motherboard.
3. Remove the onboard battery from the motherboard.
4. Short the CMOS pads with a metal object such as a small screwdriver for at least four
seconds.
5. Remove the screwdriver or shorting device.
6. Replace the cover, reconnect the power cords and power on the system.
Notes: Clearing CMOS will also clear all passwords.
Do not use the PW_ON connector to clear CMOS.
JBT1 contact pads
7.8 BMC Reset
The BMC can be reset using the UID button.
•
Reset – Press and hold the button. After six seconds, the LED blinks at 2Hz. The BMC
resets and the reset duration is ~250 ms. Then the BMC starts to boot.
•
Restore factory default configuration – Hold the button for twelve seconds. The LED blinks
at 4Hz while defaults are configured.
Note : All BMC settings including username and pass-
word will be removed except the FRU and network settings.
Firmware update – When the BMC firmware is being updated, the UID LED blinks at 10Hz.
BMC Reset Options
Event UID LED BMC Heartbeat LED
Reset Blue, Blinks at 2Hz Green, solid
Restore
Defaults
Blue, Blinks at 4Hz Off
Update Blue, Blinks at 10Hz