Appendix A: BIOS Error Codes
97
96
BIOS Beep (POST) Codes
Beep Code
Error Message
Description
1 beep
Refresh
Ready to boot
5 short, 1 long
Memory error
No memory detected in system
5 beeps
No con-in or con-out devices
Con-in includes USB or PS/2 keyboard, PCI or serial
console redirection, and IPMI KVM or SOL.
Con-out includes the video controller, PCI or serial console
redirection, and IPMI SOL.
1 beep per device
Refresh
1 beep for each USB device detected
IPMI Error Codes
Beep Code
Error Message
Description
1 continuous beep
System OH
System overheat
SuperServer 5019S-M/MR User's Manual
Appendix A
BIOS Error Codes
A-1 BIOS Error Beep (POST) Codes
During the POST (Power-On Self-Test) routines, which are performed each time the system
is powered on, errors may occur.
Non-fatal errors
are those which, in most cases, allow the system to continue the boot-up
process. The error messages normally appear on the screen.
Fatal errors
are those which will not allow the system to continue the boot-up procedure. If
a fatal error occurs, you should consult with your system manufacturer for possible repairs.
These fatal errors are usually communicated through a series of audible beeps. The numbers
on the fatal error list (on the following page) correspond to the number of beeps for the
corresponding error. All errors listed, with the exception of Beep Code 8, are fatal errors.
A-2 Additional BIOS POST Codes
The AMI BIOS supplies additional checkpoint codes, which are documented online at
www.supermicro.com/support/manuals/
("AMI BIOS POST Codes User's Guide").
When BIOS performs the Power On Self Test, it writes checkpoint codes to I/O port 0080h.
If the computer cannot complete the boot process, a diagnostic card can be attached to the
computer to read I/O port 0080h (Supermicro p/n AOC-LPC80-20).
For information on AMI updates, please refer to
.
