Supermicro SSE-G2252, Руководство пользователя

Страница: 89 / 1401

Chapter 4: Basic Management Tasks
Displaying CPU Utilization
– 91 –
buffer) until the number of packets being processed falls below the
minimum threshold. (Range: 50-500 pps; Default: 500 pps)
•
Minimum Threshold – If packet flow has been stopped after
exceeding the maximum threshold, normal flow will be restored after
usaage falls beneath the minimum threshold. (Range: 50-500 pps;
Default: 50 pps)
•
Trap Status – If enabled, an alarm message will be generated when
utilization exceeds the high watermark or exceeds the maxmimum
threshold. (Default: Disabled)
Once the high watermark is exceeded, utilization must drop beneath
the low watermark before the alarm is terminated, and then exceed the
high watermark again before another alarm is triggered.
Once the maximum threshold is exceeded, utilization must drop
beneath the minimum threshold before the alarm is terminated, and
then exceed the maximum threshold again before another alarm is
triggered.
•
Current Threshold – Shows the configured threshold in packets per
second.
W
EB
I
NTERFACE
To configure CPU Guard:
1.
Click System, CPU Guard.
2.
Set CPU guard status, configure the watermarks or threshold
parameter, enable traps if required.
3.
Click Apply.
Figure 4-21: Configuring CPU Guard
D
ISPLAYING
CPU U
TILIZATION
Use the System > CPU Utilization pages to display information on overall
CPU utilization or CPU utilization by task.