Supermicro SSE-G2252, Руководство пользователя

Страница: 164 / 1401

Chapter 6: VLAN Configuration
Protocol VLANs
– 168 –
Figure 6-17: Adding an Interface to a QinQ Tunnel
P
ROTOCOL
VLAN
S
The network devices required to support multiple protocols cannot be
easily grouped into a common VLAN. This may require non-standard
devices to pass traffic between different VLANs in order to encompass all
the devices participating in a specific protocol. This kind of configuration
deprives users of the basic benefits of VLANs, including security and easy
accessibility.
To avoid these problems, you can configure this switch with protocol-based
VLANs that divide the physical network into logical VLAN groups for each
required protocol. When a frame is received at a port, its VLAN
membership can then be determined based on the protocol type being
used by the inbound packets.
C
OMMAND
U
SAGE
•
To configure protocol-based VLANs, follow these steps:
1.
First configure VLAN groups for the protocols you want to use
(
page 1084 ). Although not mandatory, we suggest configuring a
separate VLAN for each major protocol running on your network.
Do not add port members at this time.
2.
Create a protocol group for each of the protocols you want to assign to
a VLAN using the Configure Protocol (Add) page.
3.
Then map the protocol for each interface to the appropriate VLAN using
the Configure Interface (Add) page.
•
When MAC-based, IP subnet-based, or protocol-based VLANs are
supported concurrently, priority is applied in this sequence, and then
port-based VLANs last.
C
ONFIGURING
P
ROTOCOL
VLAN
G
ROUPS
Use the VLAN > Protocol (Configure Protocol - Add) page to create protocol
groups.