Supermicro SSE-G2252, Руководство пользователя, Страница: 141 / 1401

Chapter 5: Interface Configuration
VLAN Trunking
– 144 –
Figure 5-40: Showing Traffic Segmentation Members
VLAN T
RUNKING
Use the Interface > VLAN Trunking page to allow unknown VLAN groups to
pass through the specified interface.
CLI R
EFERENCES
•
“vlan-trunking” on page 1091
C
OMMAND
U
SAGE
•
Use this feature to configure a tunnel across one or more intermediate
switches which pass traffic for VLAN groups to which they do not
belong.
The following figure shows VLANs 1 and 2 configured on switches A and
B, with VLAN trunking being used to pass traffic for these VLAN groups
across switches C, D and E.
Figure 5-41: Configuring VLAN Trunking
Without VLAN trunking, you would have to configure VLANs 1 and 2 on
all intermediate switches – C, D and E; otherwise these switches would
drop any frames with unknown VLAN group tags. However, by enabling
VLAN trunking on the intermediate switch ports along the path
connecting VLANs 1 and 2, you only need to create these VLAN groups
in switches A and B. Switches C, D and E automatically allow frames
with VLAN group tags 1 and 2 (groups that are unknown to those
switches) to pass through their VLAN trunking ports.
•
VLAN trunking is mutually exclusive with the “access” switchport mode
(see “Adding Static Members to VLANs” on page 153 ). If VLAN trunking
is enabled on an interface, then that interface cannot be set to access
mode, and vice versa.