Supermicro SSE-G2252, Руководство пользователя

Страница: 1134 / 1401

Chapter 38: Quality of Service Commands
– 1147 –
S
YNTAX
[ no ] set phb phb-value
phb-value - Per-hop behavior value. (Range: 0-7)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Policy Map Class Configuration
C
OMMAND
U
SAGE
•
The set phb command is used to set an internal QoS value in hardware
for matching packets (see Table 37-5, "Default Mapping of DSCP Values
to Internal PHB/Drop Values" ). The QoS label is composed of five bits,
three bits for per-hop behavior, and two bits for the color scheme used
to control queue congestion by the police srtcm-color command and
police trtcm-color command.
•
The set cos and set phb command function at the same level of
priority. Therefore setting either of these commands will overwrite any
action already configured by the other command.
E
XAMPLE
This example creates a policy called “rd-policy,” uses the class command to
specify the previously defined “rd-class,” uses the set phb command to
classify the service that incoming packets will receive, and then uses the
police flow command to limit the average bandwidth to 100,000 Kbps, the
burst rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set phb 3
Console(config-pmap-c)#police flow 100000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
service-policy
This command applies a policy map defined by the policy-map command
to the ingress side of a particular interface. Use the no form to remove this
mapping.
S
YNTAX
[ no ] service-policy input policy-map-name
input - Apply to the input traffic.
policy-map-name - Name of the policy map for this interface.
(Range: 1-32 characters)
D
EFAULT
S
ETTING
No policy map is attached to an interface.