Chapter 35: ERPS Commands
– 1072 –
•
Protection switching on a forced switch request is completed when the
above actions are performed by each ring node. At this point, traffic
flows around the ring are resumed. From this point on the following
rules apply regarding processing of further forced switch commands:
While an existing forced switch request is present in a ring, any new
forced switch request is accepted, except on a ring node having a prior
local forced switch request. The ring nodes where further forced switch
commands are issued block the traffic channel and R-APS channel on
the ring port at which the forced switch was issued. The ring node
where the forced switch command was issued transmits an R-APS
message over both ring ports indicating FS. R-APS (FS) messages are
continuously transmitted by this ring node while the local FS command
is the ring node’s highest priority command. As such, two or more
forced switches are allowed in the ring, which may inadvertently cause
the segmentation of an ring. It is the responsibility of the operator to
prevent this effect if it is undesirable.
Ring protection requests, commands and R-APS signals have the
priorities as specified in the following table.
•
Recovery for forced switching under revertive and non-revertive mode
is described under the Command Usage section for the
command.
•
When a ring is under an FS condition, and the node at which an FS
command was issued is removed or fails, the ring remains in FS state
because the FS command can only be cleared at node where the FS
command was issued. This results in an unrecoverable FS condition.
Table 35-2: ERPS Request/State Priority
Request / State and Status
Type
Priority
Clear
local
highest
FS
local
|
R-APS (FS)
remote
|
local SF
a
a. If an Ethernet Ring Node is in the Forced Switch state, local SF is ignored.
local
|
local clear SF
local
|
R-APS (SF)
remote
|
R-APS (MS)
remote
|
MS
local
|
WTR Expires
local
|
WTR Running
local
|
WTB Expires
local
|
WTB Running
local
|
R-APS (NR, RB)
remote
|
R-APS (NR)
remote
lowest
Содержание SSE-G2252
