Supermicro SBA-7141M-T, Руководство пользователя

Страница: 27 / 66

3-9
Chapter 3: Setup and Installation
Insert first into the 1A slot(s), then the 1B slot(s), then the 2A slot(s) and 2B slot(s).
See support information below.
Figure 3-6. Installing a DIMM into a Memory Slot
5. Gently press down on the DIMM until it snaps into place in the slot. Repeat for all
modules (see
Table 3-1 for installing DIMMs into the slots in the correct order).
6. Replace the air shroud and the blade cover and install the blade module back into
the enclosure.
7. Power up the blade unit.
3-6 Hard Disk Drive Installation
The SBA-7141M-T blade unit accommodates one internal 2.5" SATA hard disk drive,
which is mounted directly on the blade’s mainboard.
3-7 Installing the Operating System
An operating system (OS) must be installed on each blade module. Blades with
Microsoft Windows OS and blades with Linux OS can both occupy and operate within
the same blade enclosure. Refer to the SuperMicro web site for a complete list of
supported operating systems.
There are several methods of installing an OS to the blade modules.
Installing with an External USB CD-ROM Drive
The most common method of installing the OS is with an external USB CD-ROM drive.
Take the following steps to install the OS to a blade module:
DDR2 DIMM
Top View of DDR2 DIMM Slot
To Install: Insert module vertically
and press down until it snaps into
place. Pay attention to the bottom
notch.
To Remove: Use your thumbs to
gently push each release tab
outward to free the DIMM from the
slot.