- 11 -
Programming the Operator
13.
Preparation
13.1
Ensure that the Opener is engaged (refer to Sec.12). Raise and lower the door by hand to
confirm the Carriage is locked onto the chain/belt connector.
13.2
Connect the Power Cord to a properly earthed power supply. Make sure that no excess cord
hangs below the Opener when it is plugged in
.
13.3
Switch the power on at the power supply. The Courtesy Light will glow for several seconds, at
the same time the LED displays the number from “
99”
to “
11”
. When the screen shows “
- -
“ the
opener is in standby. (Fig.10).
>>
>>
14.
Coding and Deleting Transmitters
14.1
This Opener can store up to 20 transmitter codes. When the memory is full the LED display will
flash “Fu”.(Fig.11).
14.2
To code a new Transmitter:
Momentarily press the “Code” button
—
“Su” will be displayed on the LED Screen.
Momentarily press Transmitter button.
Momentarily press the same button on the transmitter a second time
—
“Su” will flash on
the LED Screen.
Change to “
-
-
“
—
This indicates the transmitter code is now stored. (Fig.11)
.
14.3
To code additional transmitters repeat step 14.2.
14.4
To delete codes from the opener press and hold the “Code” button for 8 seconds. “dL” will
display on the LED screen indicating all transmitter codes have been deleted. Fig.11)
SETTINGS & ADJUSTMENTS
Fig 10
Fig 9
Control Panel
LED SCREEN
SET
UP
DOWN
CODE