Mounting instructions TOP METOD For Two Sides 1/2
Content
3M wet wipe
MountPads 10x10mm
(
The number varies depending on the size of the top
)
Mounting
2.
Clean the surfaces.
Use the attached 3M wet wipe to clean the surfaces on
the cabinet and the Superfront top.
Finished result
3M
VHB™
GB
Surface Cleaner Sachet
For use with 3M™ VHB™ Tapes
FR
Pochette de Nettoyage
A utiliser avec les rubans 3M™ VHB™
DE
Reinigungstuch
Für den Einsatz mit 3M™ VHB™
MOUNTED SUPERFRONT SIDE
CABINET T
OP
FLAT HARD SURFACE
ABOUT 1 CM
FROM THE FRONT
EDGE
ABOUT 1 CM
FROM THE BACK
EDGE
NO MOUNTPADS
ON THE SIDE EDGES
The result varies depending on the size of the frame.
3M
VHB™
GB
Surface Cleaner Sachet
For use with 3M™ VHB™ Tapes
FR
Pochette de Nettoyage
A utiliser avec les rubans 3M™ VHB™
DE
Reinigungstuch
Für den Einsatz mit 3M™ VHB™
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
Safety!
FRONT VIEW
BACK VIEW
1.
Mount the wall brackets on the cabinet.
Mount the wall brackets supplied by Ikea before mount-
ing the Superfront sides. This is important so that the
top ends up in the right place on the cabinet.
SPACER
SPACER FOR BRACKET
3.
Attach the MountPads on the frame.
Place the frame on a hard, flat surface with the back-
side down. Attach one MountPad in each corner of the
cabinet top, inside the edges of the cabinet sides, and
spread the rest as shown at the bottom of this page.
Place them about 1 cm from the front and rear edge.
NOTE! Do not remove the cover paper from the Mount-
Pads yet!
BRACKET
Continued on back page
Superfront /+46 8 68 44 18 14 / [email protected] / www.superfront.com
