Begin the installation, by connecting an appropriate power supply
to the controller. With the controller in standby mode (off) use the
button to select each setting and buttons to adjust the
setting values to match the table below.
Once all setting adjustments have been made, and
with supply power off, connect strip as shown using
the provided adapter.
Wiring
Important: Read all instructions prior to installation.
Dream-Color Chasing RGB Controller and Remote
• Supports twelve unique IC strip styles and has pixel adjustment from
16 to 2,048 pixels to accommodate different strip lengths.
•
Input power should be 5–24 VDC (matching connected strip). Input
power connection is a 5.5 mm / 2.1 mm DC barrel connector.
• Ensure all electrical connections are secure and follow the provided
wiring instructions.
• Strips require data signal to operate properly. Use caution if cutting
strip to custom length as interrupting the data signal will cause the
strip(s) to malfunction. Strips should be powered from a single power
supply connected to the controller, as additional power connections
after the controller will cause the strip(s) to malfunction.
• Jumper wires/interconnects should be no more than 8” between strip
sections to avoid issues with data loss.
Safety and Notes
Specifications
FCC Statement
Controller Buttons
Setup and Installation
¹
Range may be decreased by interference from electrical signals and
physical barriers
²
This setting is for the full 5 m strip, part number NDC2-RGB150. Increase
or decrease the pixel count by 1 for each additional 0.1 meter of strip.
Model
RGB-MDC83
Operating Temperature
-4°–140° F (-20°–60° C )
Supply Voltage
5–24 VDC
Maximum Output Power
5 A
Maximum Remote Range¹
175 ft (53.3 m)
Terminal
Connection
Wire Color for NDC2-RGB150
V-
strip negative
black
Data
strip data
green
CLK
strip clock
blue
V+
strip positive
red
Setting
Value
IC
WS2811
LED Sequence
RGB
Pixels²
50
ON/OFF button
turns the controller on or off. The controller must
be off (powered on in standby mode) to adjust IC type, pixels,
and LED sequence.
Play/pause button
can pause and then resume dynamic modes.
Mode increase/decrease buttons
cycle up or down to the
next mode. They also adjust IC type, pixel number, and LED
sequence in the settings. M+ and M- perform the same function
on the remote control.
Speed up/down buttons
increase or decrease speed during
dynamic modes. S+ and S- perform the same function on the
remote control.
Value selection buttons
cycle through different setting types
(IC type, pixel number, and LED sequence) in standby mode.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. Any changes
or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
WIFI-CON
Important: Read all instructions prior to installation.
RGB-MDC83
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533 superbrightleds.com
Rev Date: V2 01/28/2020
User Manual
V-
V+
(Included LC4M-PT
connector)
D C