RGB / CCT / RGBW / RGBCCT LED Controller
Important: Read all instructions prior to installation.
GL-C-001W
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533 superbrightleds.com
Rev Date: V1 05/24/2022
User Manual
Safety and Notes
Controller Layout
• Do not connect controller directly to AC power. This controller requires
12–54 VDC power supply. Voltage of power supply and any connected
lights must match.
• Do not exceed max current or wattage as listed in the spec table.
Overloading the controller will cause overheating and damage
the controller.
• Ensure the power supply is not plugged into an outlet before connecting
or disconnecting any of the systems components.
• Do not expose the controller or remote to direct or indirect moisture.
• Always observe proper polarity when connecting wiring.
•
Improper installation and magnetic fields will negatively affect the
controller’s communication distance.
Compatibility
Mode
RGB-
CCT
RGBW
RGB
CCT
Dimmer
Indicator Color
White
Yellow
Blue
Green
Red
Frequency
600 Hz
800 Hz
1,000 Hz
2,000 Hz
4,000 Hz
8,000 Hz
Number of
Flashes
1
2
3
4
5
6
1. LED Indicator
LED indicator changes color to display with the current compatibility mode.
Refer to the indicator color chart to the right.
2. Reset
Press once to switch frequency. Press and hold for 2 seconds to reset
the controller. In order to be compatible with different power supplies, the
frequency can be set to 600 Hz, 800 Hz, 1,000 Hz (default), 2,000 Hz,
4,000 Hz, 8,000 Hz. Each time the frequency is switched, the indicator
light will flash pink a specific number of times to show which frequency
is now being used.
3. Opt
Press to switch modes. Press and hold for 2 seconds to add the current
ON/OFF state to memory.
Note: Each time the mode is switched, the controller will need to be re-paired.
Wi-Fi Pairing
1.
Connect to a 2.4 GHz Wi-Fi network.
Note: If device was already paired, please reset the device.
2. Apply power to the controller.
3. Open the Smart Life app to add the controller.
4. Follow the in app instructions.
5.
If the pairing is sucessful, the indicator light will stop flashing.