Superabrasive LAVINA V16E, Руководство пользователя

Страница: 14 / 28

Superabrasive Owner’s manual original language – Lavina
®
V16E 01/2021
14
7. OPERATING WITH THE VACUUM
IMPORTANT:
Before connecting the power cord to the power source, ensure that the electrical
voltage corresponds with the requirements identified on the information plate on the vacuum cleaner.
Make sure that the flexible vacuum hose is securely attached to vacuum cleaner inlet. Inspect the
power cable (and extension cords) for any signs of wear or damage. Replace if necessary.
CAUTION:
Before switching the dust collector motor “on,” always make ensure that it is at a complete
rest before energizing.
7.1 TO START THE VACCUM
The vacuum is equipped with two buttons and two lamps. The
two buttons respectively have the “ON” and “OFF” functions and the
lamps indicate whether the vacuum is connected to the power supply
“POWER” or the tank is full of liquid “FULL”.
To start the vacuum 1
st
thing to do is to connect it to the power
supply. When you make sure that the lamp mentioned above is glowing
just press the “ON” button. To turn it off respectively press the “OFF”
button.
The vacuum is equipped with two electrodes, which are also used as a stand for the vacuum
head cover. When the liquid in the vac reach the electrodes the motor will stop and the lamp “FULL”
will turn on. You must discharge the liquid from the tank and press the “ON” button in order to start
the vacuum again and continue your work.
7.2 LOCKING CASTER WHEEL
There is one locking caster wheel located on the front of the dust
collector. Locking the wheel will prevent the vacuum from moving, and
possibly causing damage or injury. The wheel should be locked on
uneven surfaces to prevent unexpected rolling or movement. To lock or
unlock the caster wheel, follow the procedure shown below.
• To lock the caster wheel, press down on the metal tab
• To unlock the caster wheel, press backwards on the metal tab
protruding from the top of the wheel assembly.
Figure 7.2
Figure 7.1