Superabrasive LAVINA LP36 Series, Руководство пользователя

Страница: 22 / 34

Superabrasive Owner’s manual original language – Lavina
®
LP36 01/2020
22
8. MAINTENANCE AND INSPECTION
Tampering w/emission control system prohibited.
Federal law and California State law prohibits the following acts or the causing thereof:
1. The removal or rendering inoperative by any person other than for purposes of
maintenance, repair, or replacement, of any device or element at design incorporated
into any new engine for the purpose of emission control prior to its sale or delivery to the
ultimate purchaser or while it is in use.
2. The use of the engine after such device or element of design has been removed or
rendered inoperative by any person.
Among those acts presumed to constitute tampering, involve the parts/systems listed below:
- Carburetor and internal parts ;
-
Spark plugs ;
-
Magneto or electronic ignition system;
-
Fuel filter element;
- Air cleaner elements;
-
Crankcase;
-
Cylinder heads;
- Breather chamber and internal parts;
- Intake pipe and tube;
WARNING!
Before cleaning and servicing the machine, you must turn the machine off and disconnect battery
and propane tank.
ATTENTION!
-
Wait until turbine impeller has completely stopped before starting servicing the machine.
- The exhaust will get very hot after running the engine for just a short time.
- Before moving the dust collector from the working area, the machine must be cleaned.
- All other equipment must be considered to be contaminated and be treated thereafter.
-
If possible, use a special suitable room.
- Proper personnel protective equipment must be used.
-
After a service, all parts that are contaminated must be taken care of properly in plastic bags,
according to all regulations.
-
If the dust collector has to be used for other purposes, it is extremely important that the
machine is cleaned to avoid the spread of hazardous dust.
In order to ensure safe and efficient operation of the dust collector, the following procedures
should be performed periodically (depending on the frequency of operation):
-
Remove and inspect the filters for any signs of excessive wear or damage. Replace as
necessary. (See section on “Filter Removal”).
- Ensure that the gaskets on the filters are free of excessive wear or damage. Replace as
necessary.
-
Inspect all electrical components (switches, plugs, cables, etc.) for damage or exposed wiring.
Replace as necessary.