Superabrasive LAVINA LP36 Series, Руководство пользователя

Страница: 19 / 34

Superabrasive Owner’s manual original language – Lavina
®
LP36 01/2020
19
7. OPERATING WITH THE TROWEL
7.1 STARTING THE ENGINE

Place foot on the trowel’s platform, grab any part of the frame, lift yourself onto the trowel,
and sit down in the operator’s seat.
NOTICE: The trowel is equipped with a safety stop switch that will not allow the engine to
start unless an operator is sitting in the operator’s seat. The weight of the operator depress
an electrical switch, which allows the engine to start.
WARNING! – NEVER disable or disconnect the safety stop switch. It is provided for the
operator’s safety, and injury may result if it is disabled, disconnected, or improperly
maintained.
NOTICE: Using the safety stop switch to stop the engine after every use will verify that the
switch is working properly. Remember to turn the key to OFF position after stopping the
machine. Not doing so may drain the battery.

The right food pedal controls blade and engine speed. The position of the foot pedal
determines the blade speed. Slow blade speed is obtained by slightly depressing the pedal.
Maximum blade speed is obtained by fully depressing the pedal.

Keeping your foot OFF the right foot pedal, turn the ignition key fully clockwise and listen for
the engine to start. Once the engine has started, release the ignition key. The throttle speed
defaults to idle. Let the engine warm for a few minutes.
7.2 STEERING
Two control levers located in the front of the operator’s seat provide directional control for
the trowel (fig. 7.2). Table 7.2 illustrates the various directional positions of the joysticks and their
effect on the ride-on trowel.
Figure 7.2