Temperature recorder and printer
27
4.
Scroll with
/
. Find the
External Memory Overwrite
in the menu and press
5.
The name of the event and its status will be displayed, for example:
Memory Overwrite:
Yes
, with YES flashing. To change the setting YES/NO, press
/
and
to
confirm.
External Memory Overwrite
will be displayed.
6.
Use
/
to scroll through the menu or press
to save the change and exit the
settings menu.
Please wait, Saving Setting
will be displayed, and then, several seconds
later, the readings screen will revert.
Settings saved
will also be printed.
C
HANGING THE
D
ATA
S
ERVER
(P
ORTAL
)
A
DDRESS
This chapter is only intended for the cellular model, VLTSC. It is for knowledgeable owners of a
site/private portal who wish to direct the data from the device to their server.
The VLTSC device is set to send the data only to a Supco portal. Any change in the following
details will prevent the data from reaching the Supco portal (it is recommended not to change
this).
The default option is set for the following:
APN name: vipoperator
APN user: vipoperator
APN password: [none],
Leave blank
Server addr: app.dev.vlts.supco.kimaia.dev
Port: 8253
To change the site
’
s address, access through the Supco terminal or through the device:
1.
Press
/
until the
Settings Submenu
is displayed.
2.
Press
to enter the settings menu,
Enter password:
will be displayed.
3.
Enter a password, (4 keys in a row). If you have not yet changed your password,
use the default password:
,
,
,
.
4.
Scroll with
/
. Find
Set Server
in the menu and press
.
5.
The APN name will be displayed, for example:
Enter APN name: vipopertaor .
The cursor
will flash after the last character in the name.
To backspace and delete the last character, press
.
To change the last character in the name, scroll with
/
.
To confirm the last character and move to the next one, press
, and so on until
the last character.
6.
Later, the user name will be displayed, for example,
Enter APN User: vipoopertaor
, with
the cursor flashing after the last character in the name. Change the User Name as in section
5 above.
7.
Later,
Enter VPN password:
will be displayed, with the cursor flashing after the last
character in the string. Change the Password as required.
8.
Later, the Port Number will be displayed, for example,
Port: 8253
,
with the cursor flashing
after the last character in the string. Change the Port Number as required and press
to
confirm.
9.
At the end,
Set Server
will be displayed.
10.
Use
/
to scroll through the menu or press
to save the change and exit the
settings menu.
Please wait, Saving Setting
will be displayed, and then, several seconds
later, the readings screen will revert.
Settings saved
will also be printed.
If no key is pressed in 30 seconds, the menu will close, the change will be saved and the display
will revert to the readings screen.
To review the addresses that were set, print the
Spec & Programming
report. See