CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015
38
Revision 05
Figure
Figure
Figure
Figure 3
333---- 6666 Master
Master
Master
Master //// Slave
Slave
Slave
Slave AU
AU
AU
AU Selection
Selection
Selection
Selection
After setup is complete, check the device type of the AU.
To query the device type:
1. Log in to the Slave AU WebOMT. (See Section 2 for the procedures to access the OMT.)
2. View the
Site
Site
Site
Site Info
Info
Info
Info
field. See
3
333
in Figure 23.
3. The device type should be “Slave AU” if the setup was successful.
Note:
Please update the day and time after a Slave AU changes to a Master AU.
3.7.
3.7.
3.7.
3.7. OMT
OMT
OMT
OMT Parameters,
Parameters,
Parameters,
Parameters, Alarms
Alarms
Alarms
Alarms and
and
and
and Commands
Commands
Commands
Commands for
for
for
for the
the
the
the AU
AU
AU
AU
See Section 2.3, OMT Display, for information on how to use the WebOMT interface to view and change parameters
and run commands.
3.7.1.
3.7.1.
3.7.1.
3.7.1.
AU
AU
AU
AU User
User
User
User and
and
and
and Network
Network
Network
Network Parameters
Parameters
Parameters
Parameters
Table 5, Table 6 and Table 7 show the device information, TCP/IP and SNMP network management parameters,
respectively, that are displayed on the WebOMT under the
User
User
User
User Parameters
Parameters
Parameters
Parameters
tab.
