SUNWARD SWE50B, Руководство по эксплуатации и техническому обслуживанию

Страница: 75 / 197

68
damaged. This will cause an electrical short circuit and may lead to malfunction of the machine.

Do not use water to flush the inside of the operator’s cab.

Do not allow water to get into the electrical components.

Service relating to the electric system is checking fan belt tension, checking damage or wear to the fan
belt and checking battery fluid level.

Never install any electric elements other than those specified by SUNWARD.

When working at seashore, carefully clean the electric system to prevent corrosion.
5.1.9 Hydraulic System Maintenance
Hydraulic equipment is at a high temperature during operations and immediately after operations. During
operation, it’s also under high pressure, so be careful of the following points when carrying out inspection
and maintenance of hydraulic related equipment.

Stop the machine on level ground, lower the bucket completely to the ground.

Always stop the engine and release pressure in hydraulic piping.

Immediately after the engine is stopped, the hydraulic oil and lubricants are at a high temperature and
high pressure. Wait for the temperature to go down before starting the maintenance operation.

Even when the temperature goes down, the circuits may be under internal pressure, so when loosening
plugs, screws, or hose connections, do not stand directly in front. Loosen gradually to release the
internal pressure before removing.

Always release the air in the hydraulic tank to remove the internal pressure before carrying out
inspection and maintenance of the hydraulic circuit.

Inspection and maintenance works include checking the hydraulic system for oil level, replacement of
filter elements and replacement of hydraulic oil.

If high pressure hoses have to be removed, check that there is no damage to the O-rings. If any
damage is found, replace the O-ring.