SunTech ST300 Series, Руководство по эксплуатации

Страница: 36 / 146

Doc. Title Author Page of Pages
ST300/340 OPERATION MANUAL
– LATAM
HG.Park
36 of 146
Concerning Doc. No. Rev. Date
Features and How to set parameters 1.41
26 May. 2015
Suntech International Ltd. Confidential Document
variant models of the ST300 Series specified above have a useful detection function, named
“Dead Center
Checking
”, which prevents drivers from doing such a bad driving behavior.
This function can be operational after checking the values of the relevant parameters such as :

CHK_GEAR(checking enable/disable),

CHK_GEAR_RPM

CHK_GEAR_TIME
If a vehicle has been being driven under a driving condition of lower than a preset value of
‘
CHK_GEAR_RPM
’
for a longer time period than the present time period of
“
CHK_GEAR_TIME, this feature
assumes that the vehicle is driven for this time period as a
“bad driving behavior” (i.e. “driving vehicle down with
the gear being positioned <neutral>) and makes a report, which is named
as “Travel Event Report”. In that
case, such a bad driving time is reported to the server of the device.
B.
“Travel Event Report” for Economical Driving to save fuel
User of device can save
fuel in driving the vehicle by utilizing “Travel Event Report” if he/she pre-sets the 2
parameter
s (“ECO_MAX_RPM” and “ECO_MIN_RPM”) in order to make a range.
After value of the 2 parameters is pre-set and when driving is over, the device will report to its server about the
driving time by 3 categories:

Category A: How long the vehicle has been driven
covering “ECO_MAX_RPM” and
“ECO_MIN_RPM”

Category B: How long the vehicle has been driven under the
“ECO_MIN_RPM”

Category C : How long the vehicle has been driven over the
“ECO_MAX_RPM”
4-12. Driver ID parameters
4-12-1. How to add Driver ID
This chapter shows how to add the
‘driver ID’ to the ‘registration table’ as shown on the bottom part of this chart. If
a vehicle is driven without processing to register driver ID in proper way, this feature assumes that the vehicle is
driven by non-registered driver. In this case, the device can activate immobilizer.
HDR DEV_ID VER DID_POS (1
st
) DID (1
st
)
… …
DID_POS (last) DID (last)
Field Marks Value Meaning
HDR
“ST300HAD”
Command type.
DEV_ID 9 char Device ID.
VER
“02”
Protocol Version.
DID_POS (1
st
) String
“1~ 100”
Index position of driver ID to save.
DID(1
st
) String 14hex digits Driver ID.
…
…
DID_POS (last) String
“1~ 100”
Index position of driver ID to save.
DID(last) String 14hex digits Driver ID.
<Example>
[command] ST300HAD;100850000;02;001;00001000000000;002;00002000ABCDEF;005;00003333AAAAAA;
…
[response] ST300HAD;Res;100850000;267;001; 00001000000000;002; 00002000ABCDEF;005;00003333