LCD Display – Cont.
“CURRENT” HUMIDITY.
When the
machine is turned on, the default display
function goes to “CURRENT” HUMIDITY.
“CURRENT” wording in the square box will
flash for 3 sec and 2 digits Relative Humidity
figures display the current ambient humidity.
“SET”
HUMIDITY.
While
“SET”
HUMIDITY function is chosen, “SET”
wording in the square box will flash for 3 sec
and the bottom 2 digits Relative Humidity
figures also flash continuously until the user
set the desired humidity which is from 25%
to 80%. “- - %RH” is the value beyond this
range,
which
read
as
nonstop
dehumidification.
“TIMER” CLOCK.
While “TIMER”
CLOCK time is chosen, “TIMER” wording in
the square box will flash for 3 sec. The
bottom four digits show how many
HOURS
and MINUTES
the “TIMER” is. In STANDBY
mode, the four digits (- - : - -) flash
continuously until user sets the TIMER from
00:10 to 23:50 hours. Once the “TIMER” is
set and machine starts running, the four
digits displays remain running time of the
current TIMER., “- - : - -” is the value beyond
this range, which read as nonstop
dehumidification.
l
Inspect pump tube.
Make sure the pump tube is completely unwrapped
and not kinked. Failure to do so can cause water to back up in the pump
and leak out. The control panel may signal this problem by displaying
“ER00”
l
Inspect filter.
Look for accumulated dust and dirt that would restrict airflow
through the filter into the unit. If any is visible, vacuum out the debris.
Do
not wash the filter
, as it will reduce the effectiveness of the electrostatic
material.
Important:
Replace the filter whenever
l
It has been vacuumed clean 3 times.
l
It has been used on a mold remediation job.
Periodically Inspection (as needed)
Make sure the unit is unplugged. Remove housing, in order to locate the coil,
pump and drain hose.
l
Check coil and clean visible dirty
n
Vacuum both sides of the coils until clean.
l
Check pump
n
Inspect and clean the pump system regularly to maintain effective
operation. Remove one screw to open up the top cover, and then
open up the second cover. Clean the float shaft to make sure the
floating switch can operate smoothly.
l
Check drain hose
n
Look for obstructions. Disconnect and clear any debris present.
Warranty
SunTec warrants to the original purchaser that if, within a period of 12 months
from the date of purchase, this equipment is found to be defective either in
original materials or workmanship (excluding normal usage wear and/or
mishandling or abuse) the faulty part will be replaced free of charge upon
presentation of the appropriate evidence, provided the unit is returned to the
original supplier. Shipping expenses are not covered under the warranty.
