Sunsystem BURNIT AMBIENT V2 4G 10 Plus, Инструкция по установке и эксплуатации

Страница: 4 / 32

4
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
!
DANGER of fire when burning
flammable materials or liquids.
- Flammable materials/liquids
must not be left in close proximity
of the burner and heating boiler.
- Instruct system user of the
allowed minimum clearances
from surrounding objects.
Table 1.
Electricity consumption of the stove
Maximum electrical input
450 W
Electrical input at nominal heat
output
70 W
Electrical input at minimum heat
output
35 W
1.2.2. Instructions to installation user.
$
DANGER of intoxication or
explosion
Toxic gases may be discharged
when burning waste, plastics,
liquids.
- Use only the fuels indicated in
this manual.
- In case of danger of explosion,
ignition or discharge of exhaust
gases in the room, stop the pellet
burner from operation.

CAUTION! Risk of injury/damage
to equipment due to incorrect
operation.
- Pellet stoves may be operated
only by persons who are familiar
with the instructions of use.
- As a user you are allowed only
to put the stove in operation
or out of operation, set up the
operation mode and clean the
stove.
- Access of unattended children to
premises with a working stove
inside is prohibited.
Safety rules for user operation:
- The pellet stove is designed to work
even in extreme weather. Still in case
of strong wind or very chill weather
the safety system of the product may
automatically turn of the pellet stove.
In that case the end user must notify
authorized service /installer BURNiT.
It is not recommended to deactivate
or restart the safety functions of the
product at your own.
- Operate the stove on recommended fuel
only, and to that end you must regularly
inspect the boiler room.
- It is forbidden to install the pellet stove in
wet or moist spaces such as bathroom,
laundry etc. It is forbidden to touch the
pellet stove with wet hands or feet.
- The door of the pellet stove must be
closed when the product is in working
mode.
- Do not use flammable liquids for ignition
or increase of burner output.
- Clean the stove surface using non-
flammable agents only.
- Do not place flammable objects onto
the burner housing and heating stove
cabinet or in their proximity.
- Do not store flammable materials in the
stove room.
- - It is mandatory to strictly observe
instructions for connecting the burner
to power network as well as to all
peripherals.
- Structural changes of the stove by user
can cause damage to equipment or
injury.
- Do not allow contact transmission of
electrical wire or touch any part of the
stove, where the surface temperature
can exceed 70 °C.
- This manual should be kept throughout
- Stove installation room must be
equipped with fire extinguisher in case
of fire in the exhaust gases tube.