Sunsystem BURNIT AMBIENT V2 4G 10 Plus, Инструкция по установке и эксплуатации

Страница: 16 / 32

16
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
8.3.5. Cleaning the door glass
Door glass is self-cleaned during stove
operation. However, after several hours
of operation, the glass may become dirty
on the inside. The reason for this is the
quality of the pellets and the operation of
the exhaust system. The glass should be
cleaned when the fire extinguished and
cooled. Use a cotton cloth and a small
amount of glass cleaning agent.
After each cleaning check for distance
of 2mm (two) between glass and upper
edge of the door
8.3.6. Check /change of the door
insulation rope
Rope ensures door tightness and proper
operation of pellet stove.
Check the insulation rope periodically.
If any damage is found, please contact
an authorized service to replace the
insulation rope with a new one.
The rope is not covered by warranty.
8.3.7. Removing the ash from the pellet
stove
Check the ash container at bottom part of
pellet stove. Turn off the stove, wait until
gets cool and then clean it. It`s mandatory
to clean the ash container daily. Dispose
the ashes in a non-combustible container
with a lid.
8.3.8. Cleaning of the burner
Use a vacuum cleaner to clean the burner
from ash once per day. Cleaned burner
ensures proper stove operation
Scheme 6. Cleaning of the burner
When burner apertures are filled with
impurities, open and clean the burner.
8.3.9. Cleaning of pellet hopper
It is recommended the periodic hopper
cleaning (at least once per month).
The cleaning must be done as following:
first, empty the pellet hopper; second,
use a vacuum cleaner to clean the hopper.
In case of lot of dust and sawdust into
the pellet hopper during stove operation,
immediately stop operation of stove
and clean the pellet hopper and burner
properly. Refuel pellet hopper again. If
pellet hopper still has of lot of dust and
sawdust, replace the used pellets with
quality ones.
When burner apertures are filled with
impurities, open and clean the burner.
8.3.10. Cleaning of silicone hose of
pressure switch. At least once a year.
8.3.11. Cleaning the ash from the damp
tubes.
When using low quality pellets, we
recommend doing this once a month.