Step 1a
Small bracket A (1)
Clock Assembly (J)
Upright (4)
Small bracket B (1)
Upright
Connection
Upright
Upright
Disc (I)
Top (1)
Allen Screw
A (8)
Large bracket B (1)
Parts Included:
Centre
Disk (1)
Assembly Time:
Usage:
Allen Screw
B (4)
Large bracket A (1)
When using this weather station outside, place unit in shaded area away from direct sunlight for
most accurate reading of gauges, as direct sunlight may cause some
deviation in gauge readings.
Assembly:
Adjustment:
1) Remove round plastic cap to expose adjustment dial. To adjust the Clock reading, turn adjust-
ment dial to adjust needle on the face of the unit.
2) Temperature gauge is self-adjusting.
3) Replacing Battery: On back of clock, remove round plastic cap by pulling metal ring. Insert
battery matching the “–” and “+” markings as indicated on the inside of the battery housing, to
the markings located on the battery, and re-attach round plastic cap. Requires 1 “AA” Battery
(Included).
Time:
20-30 minutes
Step 1b
Step 2
Plastic Cap
Battery
1) Screw Large Bracket
A in between two of
the uprights. Then
Screw Large Bracket B
between the remaining
two uprights. Now fi t
the downward notch on
Bracket B into the up-
ward notch on Bracket A
by placing the uprights
at an angle to each other,
until the notches line up.
Tighten with Allen Key.
2) Now Screw in the Small Bracket A into the uprights then fi t
Small Bracket B into the notch in Small Bracket A and screw it
into the remaining uprights. Then tighten them with Allen Key.
12
���
���
�� ��
��
��
��
�
�
���
�
��
��
�����������
��
��
���
���
�
1
2
3
4
6
8
9
10
11
MADE IN CHINA
- AA 1.5V +
Adjustment
knob for
clock
M4 Allen
Wrench
(1)
Foot Tab
(4)
1/8 Allen
Wrench (1)
Allthread
Sleeve (1)
Allthread
(1)
Stake (4)
1/8 Allen
Key
