8
Sedeo Ergo Rev.1.0
EN
GLISH
4.0 Setting up the seating system
The average wheelchair user does not exist. This is why Sunrise Medical
wheelchairs can be adjusted according to specific needs of the user.
In this, we make a distinction between wheelchair settings and
wheelchair seating adjustment options. Settings are carried out once,
the first time the wheelchair is going to be used. They must be executed
by qualified specialist, unless explicitly stated otherwise. Seating
adjustment options can be carried out by the user. These adjustment
options do not require the use of tools.
4.1 Pre-set seat width
Pre-set the armrest width:
•
Loosen the two screws (5.0mm Allen key) on the traversing tube as
shown in (Fig. 4.1 - A).
•
Move the armrest receiver brackets to the desired position.
•
Tighten the screws firmly prior to use.
CAUTION!
•
Please check that the new arm rest position does not interfere with
any seat positioning.
Pre-set the seat plate width
Lift the seat cushion off the Velcro© strips to access the seat plates.
•
Use a 5.0 mm Allen Key, (Hex Wrench).
•
Adjust the seat plate width by loosening the four screws, circled in
Fig. (4.2).
•
Slide the plates outwards or inwards to achieve the required seat
width.
•
The seat width is indicated by the scale that runs alongside each slot
(Fig.4.2).
•
Tighten the four screws securely.
Pre-set the back plate width
Lift the back cushion off the Velcro© strips to access the back plate
(Fig.4.3).
•
Use a 5.0 mm Allen Key, (Hex Wrench).
•
Loosen all of the 12 screws located within the slots.
Define the back plate width
•
Slide the side plates in or out to the required width.
•
Tighten the 8 screws securely (white marked in Fig. 4.3)
Positioning/centering the back plate width
•
Slide the total to the left and the right to align with the marker pin.
•
Use the measuring scale embedded on the back plates and the
marker pin for reference.
•
Tighten all remaining 4 screws securely (black marked in Fig. 4.3).
•
Fit a backrest cushion onto the back plate.
CAUTION!
After finishing seat width adjustments, make sure that the armrest can
be flipped up without colliding with the backrest. Not doing so can lead
to damaging rhe product severely.
&
J3 Back, (Fig.4.3.1):
NOTE: The Jay 3 Backrest can be used in conjunction with the Sedeo
Ergo seating system. Please refer to the J3 Back Owner’s Manual for
fitting and adjustment.
Fig. 4.1
Fig. 4.2
Fig. 4.3
A
Fig. 4.3.1
Содержание QUICKIE Sedeo Ergo
Страница 75: ...75 Sedeo Ergo Rev 1 0...
