25
EN
GLISH
Q700 M/M HD/F/R/UP-M/UP-F Rev.G
7.0 Transportation
7.1 Transport of the wheelchair in a car
Getting in and out of the vehicle
DANGER!
•
Confirm that the vehicle is suitably equipped to transport a
passenger in a wheelchair, and ensure the method of access/
egress is suitable for your wheelchair type. The vehicle
should have the floor strength to take the combined weight
of the occupant, the wheelchair and accessories.
•
Use a ramp (or lifting device) suitable for the entire weight of
the wheelchair (including user) for entering the vehicle.
•
The wheelchair should be secured in a forward facing
direction. This wheelchair is approved for use in cars and
meets the requirements for forward facing transport and
head on collisions. The wheelchair has not been tested for
other positions in a vehicle (Fig. 7.1).
CAUTION!
•
Sufficient space should be available around the wheelchair
to enable clear access to attach, tighten and release the
wheelchair and occupant tie down restraints and safety belts.
•
Ease of access to, and manoeuvrability in, motor vehicles
can be significantly affected by wheelchair size and turning
radius; smaller wheelchairs and/ or wheelchairs with a shorter
turning radius will generally provide greater ease of vehicle
access and manoeuvrability to a forward-facing position.
Securing the wheelchair with a strap restraint system
This wheelchair has been successfully crash tested in
accordance to: ISO 7176-19:2008, using a representing restraint
system.
•
Use 6 straps if the 4-point system is not rated to the weight
of the wheelchair (2 at the front and 4 at the back) that
conforms to ISO 10542-1 (international). Standard straps are
only tested to 85kg.
•
It is recommended to use with a 4-point strap restraint
system rated for the total weight of the wheelchair
including any options (Heavy Duty System) - 2 at the front,
2 at the back (Fig.7.2 & 7.3) that conforms to ISO 10542-1
(international).
NOTE:
Use WTORS in accordance with the WTORS#1
manufacturers instruction.
Terminology explained:
1) WTORS: Wheelchair Tie-down Occupant Restraint System
Recommended angles for Tie-Down straps (Fig. 7.2 - 7.3).
Fig. 7.1
40°
300
25°
25°
1
60
°
45°
30
°
10°
10°
300
1
Fig. 7.2
Fig. 7.3
Front Securement Points
Rear Securement Points
Содержание Quickie Q700 M
Страница 150: ...150 Q700 M M HD F R UP M UP F Rev G ...
Страница 151: ...151 Q700 M M HD F R UP M UP F Rev G ...