Z-Wave In-Wall Smart Switch SR-ZV9100A-A
Safety & Warnings
•
DO NOT install with power applied to device.
•
DO NOT expose the device to moisture.
Quick Start
How to install:
•
Step 1: power on the Z-Wave In-wall Smart switch.
•
Step 2: activate inclusion mode on your Z-Wave controller.
•
Step 3: activate inclusion mode of the switch by triple press the action button on the switch. The switch
will be included to Z-Wave network.
Product Description
The in-wall smart switch is a Z-Wave device designed to work with various types of light sources. It may be
connected to two-wire or three-wire configuration so it can operate with or without neutral lead. The switch
can switch ON/OFF connected light source either through Z-Wave devices or through the wall switch
connected directly to it.
The switch can be included and operated in any Z-Wave network with other Z-Wave certified devices from
other manufacturers and/or other applications. All non-battery operated nodes within the network will act
as repeaters regardless of vendor to increase reliability of the network.
The encryption mode that the switch supports is S2 Unauthenticated. When the switch is being included
into a Z-Wave network, you can use your primary controller/gateway to enable encryption mode or disable
encryption. (The primary controller/gateway shall support encryption mode configuration). The switch
supports OTA and can update firmware wirelessly.
Action button
AC power input
Load output
Reset
L
L
N
N
OUT
AC 100-240V
Switch input
Function Introduction
S
1
C
O
M
(2-wire with No Neutral input)
(3-wire with Neutral input)
(2-wire with No Neutral output)
(3-wire with Neutral output)
In-wall Smart
Switch
SR-ZV9100A-A(868.42MHz)
Ratings:230V~,50Hz,MAX:4.8A ( )
Made in China
MAX:2.4A ( )
1
