RF Wireless Single Color/Dual Color Remote
09.2803A.04459
Switch between single color mode or dual color mode:
Single color mode:
(e.g.
zone
4
), press and hold down
4
then zone
4
was under single color mode. Under this model, and will not working.
Dual color mode:
Choose a zone(e.g.
zone
4
), press and hold down
4
& together about 5-10 seconds,
then zone
4
was under dual color mode.
Choose a zone
& together about 5-10 seconds,
Note:Before the first use, please remove the protective film on the battery.
Function introduction
Important:
Read All Instructions Prior to Installation
Output
RF signal
Operation Frequency
868/915/434MHz
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
136.3x38.9x10.7mm
Front side
Back side
•
Control 6 zones of receivers separately
• Single color/dual color controller
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
•
This device contains a button lithium battery that shall be stored and disposed properly.
•
DO NOT expose the device to moisture.
Safety & Warnings
Power Supply
3V(1xCR2025 battery)
Control the receiver’s channel 1
and channel 3.
Press and hold down to adjust
warm white between 0%-100%
Only work with dual color,
it's useless for single color.
6 zones control.
Click to choose the zone,
Press and hold down to turn
on/off the zone
Control the receiver’s channel 2
and channel 4.
Press and hold down to adjust
cool white between 0%-100%
Only work with dual color,
it's useless for single color.
On/Off
Press and hold down to increase light
intensity smoothly
Press and hold down to decrease light
intensity smoothly
1
2
1
Pair with RF receiver
Step 3:
Choose and click a zone number(
e.g.
zone
4
)
Step 2:
Click the “
Learning Key
” button on RF receiver to set it into pairing status
Note: one receiver can be paired with max 8 remote controls.
Learning
Key
RF LED Receiver
Step 1:
Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 4:
Click any of the four buttons , LED lights connected with
the RF receiver flicker once means the receiver is paired with zone 4 successfully.