RF CCT Controller
09.283CT.04337
Note:Before the first use, please remove the protective film on the battery.
Function introduction
Important:
Read All Instructions Prior to Installation
Output
RF signal
Operation Frequency
868/915/434MHz
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
136.3x38.9x10.7mm
Front side
Back side
•
Control 6 zones of RF receiver
• Dual color controller
• Compatible with universal serie RF receiver
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
•
This device contains a button lithium battery that shall be stored and disposed properly.
•
DO NOT expose the device to moisture.
Safety & Warnings
Power Supply
3V(1xCR2025 battery)
Control the receiver's cw channel,
Press and hold down to increase/
decrease light intensity
6 zones, click to choose a zone,
press and hold down to turn ON/OFF
corresponding zone
Control the receiver's ww channel,
Press and hold down to increase/
decrease light intensity
On/Off
Press and hold down to increase light
intensity smoothly
Press and hold down to decrease light
intensity smoothly
Pair with RF receiver
Step 3:
Choose and click a zone number(
e.g.
zone
4
)
Step 2:
Click the “
Learning Key
” button on RF receiver to set it into pairing status
Note: one receiver can be paired with max 8 remote controls.
Learning
Key
RF LED Receiver
Step 1:
Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 4:
Click any of the four buttons , LED lights connected with
the RF receiver flicker once means the receiver is paired with zone 4 successfully.
After pairing
,
c
hoose
and
click
one
or
multiple zone nunbers , then press and
hold any of the four buttons to do the operate