MN5000000073
Page 6
⚫
When the LED is flashing, there is traffic on the network to
which the PCIe 2.5G 4-Speed Multi-Gigabit Network Card is
connected
2.2 Hardware Installation
1.
Turn off the power to your computer.
2.
Unplug the power cord and remove your computer’s cover.
3.
Remove the slot bracket from an available PCIe slot.
4.
To install the card, carefully align the card’s bus connector with
the selected PCIe slot on the motherboard. Push the board down
firmly.
5.
Replace the slot bracket’s holding screw to secure the card.
6.
Secure the computer cover and reconnect the power cord.
2.3 Driver Installation
The following section shows you how to install PCIe 2.5G 4-Speed
Multi-Gigabit Network Card driver on different operating systems.
2.3.1 Installation for Windows
Insert the provided CD into your disk drive. The CD-ROM
