SOLFLO Pump Assembly Instructions
1.
Remove pump base from shipping box and place on
a flat surface.
2.
Rest the pump end on the base and align the two
feet over the two mounting holes.
3.
Place the stainless steel flat washers over the base
flanges on each side of the pump. Insert the two
stainless steel screws and start the two base
mounting screws by hand.
4.
Make sure the pump is straight in the base and the
screws are aligned vertical before tightening.
5.
Tighten the screws until it just touches the base and
then turn it an additional 1/4 turn. Do not over
tighten the screws in the plastic base. If you see the
stainless washer bend then that is too much.
