Operating Instructions
Congratulations on the purchase of your new
SUNPAK tripod. Your tripod has been designed
to be a sturdy, rugged, and dependable product and
will provide you with many years of reliable service.
Please spend a few moments reviewing these
instructions, so that you can take full advantage
of your tripod’s features and capabilities.
SUNPAK LIMITED LIFETIME WARRANTY
This SUNPAK product has been carefully manufactured, accu-
rately adjusted, inspected and thoroughly tested before shipment
to assure you of the highest quality.
Should this SUNPAK product require service, we will repair or
replace, at our option, any part or the product itself, which our
examination shows to be defective in material or workmanship.
This warranty does not apply to wear and tear associated with
the normal use of the product. This warranty is non-transferable.
Repairs will be made to the product at no charge, under the
terms of the warranty as stated above, only when accompanied
by a dated and itemized bill of sale and nominal handling charge.
Be certain to follow all assembly and/or operating instructions
with this product. This warranty is not valid if the product has
been misused or damaged in any way that is beyond our control
or through normal wear and tear associated with use. This war-
ranty applies only to the product and we are not responsible in
any way for losses, damages or any inconvenience caused by
equipment failure.
Some states do not allow the exclusion or limitation of conse-
quential damages, so the above limitation or exclusion may not
apply to you. This warranty gives you specific legal rights and
you may have other rights which may vary from state to state.
Should service be required, the product should be carefully
packed (in the original packaging if possible ) and sent, prepaid
and insured, along with a check or money order for $15.95
(shipping and handling), to the address listed below. A note
briefly describing the nature of the defect should also be en-
closed to expedite handling.
Proof of purchase and payment for shipping and handling
OWNER’S RECORD
Please complete this section and retain with your original bill of
sale for your records.
Purchase Date ________________________________________
Model _______________________________________________
Dealer’s Name ________________________________________
Address _____________________________________________
City ________________________________________________
State ___________________ Zip Code ____________________
ToCAD America Inc.
Sunpak Tripod Division
53 Green Pond Road
Rockaway, NJ 07866
973-627-9600
tocad.com
Precautions
•
Insure that all handles, knobs and leg locks
are properly tightened, and that all three
legs are fully angled opened before use.
•
Do not
carry or transport the tripod with the
camera equipment attached (as example
but not limited to: over your shoulder or
cradled in your arms).
•
Do not
Oil or Grease any part of the tripod.
•
Do not use any solvents or thinners to clean
your tripod. Use mild detergent and wipe dry
with a soft, lint-free cloth only.
•
Do not
store or expose your tripod to
excessive heat or cold or use close to any
flame or fire.
•
Do not
exceed the load limit for this product.
All Specifications Subject to Change without Notice.
Cat. no. 620-723-CFT-PX
Short Center Column
Your Sunpak PRO
723PX tripod also
comes with a Short Cen-
ter Column for low angle
use. To remove the
standard center column,
first loosen the Center
Column Lock Knob and
simply unscrew the
accessory hook plate
from the bottom of the
Center Column, and
remove it from the tripod
body. Then install the
Short Center Column for
use.
Reversible Threaded Screw
Your PRO 723PX comes with
a reversible 1/4”-20 / 3/8”
screw. To switch sizes,
unscrew the Center Column
plate located at the top of the
Center Column. Remove the
threaded screw from the
receptacle, turn upside-down
and screw the Center
Column plate back on the
Center Column.
