Assembly Instructions
1.
Connect the two ends of LED light cord together and screw over the plastic collar. Push and place the
LED light in the water basin.
2.
Adjust pump flow as needed. Attach tube to pump. Put in basin.
3.
Push the cable with pin into the transformer, plug and screw over the plastic collar.
4.
Run the cable through the groove of the access door. Fix the cover properly.
5.
Fill the basin with enough water then connect the pump cord
to the socket.
Important Care Notice
1.
Fill the fountain with sufficient water to ensure the pump is
well submersed.
2.
Clean and top off the water on a regular basis.
3.
Always shut off the power before cleaning and maintaining
the pump.
4.
Never allow the fountain pump to run dry as this will cause
damage and invalidate the warranty.
5.
It is not recommended to leave the fountain running
constantly. It is suggested that the fountain be turned off regularly.
Winter Care
(for outdoor fountains)
1.
During winter never allow ice to form in the bowls as the force of the ice forming will crack the bowls. Drain the
fountain and store indoors.
2.
The pump should be disconnected from the main supply, removed from the fountain, and cleaned in the
following way:
