Note
: When first used, there may be air in the pump. It may take several minutes for trapped air to escape, allowing water to flow.
You may need to add more water as the pump begins to circulate water through the fountain.
09/2019
Page 2 / 2
MZ14871BB
5. *Run the light cable from the small tier down through the medium tier. Slide the tiers over the water tube and
firmly connect the light cables from both tiers to the light splitter cable (attached to the pump).
6.
Gently place the tiers onto the large column, ensuring all cables are inside the fountain. Do not allow the
cables to get caught/pinched between the tiers as this can damage the wires.
7. Place the rubber washer (from step 3) on the water tube. Twist the ball topper onto the water tube until it is
secure; do not over-tighten.
8. Firmly connect the pump power cable to the AC adapter.
9. Fill the large tier and medium tier with enough water to keep the pump fully submerged during operation.
10.
Plug the power cord into a properly grounded GFCI outlet.
IMPORTANT INFORMATION
USE & CARE
•
For outdoor use only. Some splashing is normal; adjust the flow rate on the pump if the water rate is too high.
•
Check the water level frequently to ensure the pump remains fully submerged; never allow the pump to run dry as it will burn out the motor.
•
Only use water in this fountain. Distilled water will help prevent mineral buildup but is not required, avoid heavily chlorinated tap water as
it may damage the fountain or pump.
•
Periodically change the water to keep the water, fountain and pump clean. Remove scale and buildup regularly.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use a pressure washer or abrasive materials to wash the fountain
• Always shut off the power supply before cleaning and maintaining the fountain and the recirculating pump.
•
Take care when handling the pump; only pick it up by the body of the pump, never by the power cord.
•
During freezing weather, drain the fountain, disconnect the pump and store indoors; allowing ice to form may crack the fountain.
TROUBLESHOOTING
• Ensure that the pump is fully submerged and add water to the basin if necessary.
• Check the pump and tubing for obstructions.
•
Check the flow control on the body of the pump as it may need to be adjusted to achieve the desired flow rate.
•
If the light is not working, ensure the cables are fully connected and the seal is adequately tightened (do not over-tighten).
•
If water is not flowing within several moments of the fountain being plugged in, unplug the power supply for a few moments and plug it back
in; the pump may have trapped air which can prevent water from circulating properly.
•
Check to make sure the power outlet is working; if in doubt about electrical connections, consult a certified electrician.
Any modification or failure to follow the recommended care will void the product warranty.
