sunjoe SPX7000E, Руководство по эксплуатации

Страница: 2 / 20

2
• Keep children away – This high-pressure electric pressure
wet/dry vacuum must not be used by children or
untrained personnel.
• To ensure appliance safety, use only original replacement
parts from the manufacturer or those approved by the
manufacturer.
m
WARNING!
During cleaning, maintenance, or when
replacing parts, disconnect the machine from its power source
by removing the plug from the socket outlet.
• Check for damaged parts – Do not use the appliance if
the supply cord or other important parts of the appliance
are damaged (e.g. safety devices, high-pressure hoses,
trigger gun).
m
WARNING!
If an extension cord is used, the plug and
socket must be of watertight construction.
NOTE: It is not recommended to use an extension cord with
this pressure wet/dry vacuum.
m
WARNING!
Inadequate extension cords can be
dangerous.
m
WARNING!
Power cords on drums should always be
completely unwound to prevent the cord from overheating.
• Power cord connections should be kept dry and off the
ground.
• If the power cord is damaged, do not use the appliance.
Contact your authorized Snow Joe
®
+ Sun Joe
®
dealer or
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
• Keep the machine on a stable, flat surface during operation,
handling, transportation, and storage. Sudden overturn of
the machine can cause bodily injury.
• In the event of an accident or breakdown, switch off the
machine immediately. (If contact with detergent occurs,
rinse with an abundance of clean water.)
General Safety for Pressure
Washer
m
WARNING!
When using as pressure washer, high-
pressure jets can be dangerous if subject to misuse. The
jet must not be directed at persons, pets, live electrical
equipment, or the appliance itself.
m
WARNING!
Water that has flowed through backflow
preventers is considered to be non-potable.
m
WARNING!
High-pressure hoses, fittings, and
couplings are important for the safe operation of the appliance.
Use only hoses, fittings, and couplings recommended by the
manufacturer.
• Check the water temperature – This pressure washer is
not meant to pump hot water. NEVER connect it to a hot
water supply as it will significantly reduce the life of the
pump.
• Do not direct the jet at yourself or others in order to clean
clothes or footwear.
• Risk of explosion – Do not spray flammable liquids.
• This high-pressure electric pressure washer must not be
used at temperatures below 32ºF (0°C).
General Safety for Wet/Dry
Vacuum
m
DANGER!
Do not manually place objects into the
vacuum inlet while operating the unit as this can seriously
damage the unit and/or harm the operator. Keep both hands
away from the air inlet while the power is on.
DO NOT ATTEMPT to remove material or hold material to be
vacuumed when the wet/dry vacuum is on. Make sure the wet/
dry vacuum is off when clearing jammed material from the
vacuum inlet.
m
CAUTION!
Do not operate the wet/dry vacuum
without the dust compartment properly attached. If the dust
compartment is not properly attached, the machine may
unintentionally move forward and throw out objects through
the blowout opening and cause injury.
• Maintain the wet/dry vacuum with care – Keep the
air inlet/outlet clear and clean for optimal performance
and to reduce the risk of injury. Keep the housing dry,
clean and free from oil and grease. Follow the additional
recommendations described in the maintenance section of
this manual.
• Avoid dangerous environments – Do not use the wet/
dry vacuum in rain, damp or wet locations. Do not operate
the wet/dry vacuum in gaseous or explosive atmospheres
or use the wet/dry vacuum to pick up flammable or
combustible liquids. Motors in these tools normally spark,
and the sparks might ignite fumes.
• Keep firm footing and maintain good balance at all times.
Do not overreach. Overreaching can result in loss of
balance.
• Do not pick up anything that is burning or smoking, such as
cigarettes, matches or hot ashes.
• Do not use without the dust compartment or filters in place.
• Do not put any object into the tool's openings. Do not use
the tool with any opening blocked; keep openings free of
dust, lint, hair or any other object that may reduce air flow.
• Check the work area before each use. Remove all objects
such as rocks, broken glass, nails, wire or string which can
be thrown or become entangled in the machine.