Parameter Setting
Thermal Imaging Integrated Network Camera
User Manual
56
Issue V1.1
（
2022-05-21
）
Figure 6-4
Image interface
Step 1
Click
in the lower left corner of Sensor Setting, and choose
Debug
Mode
.
Step 2
Drag the slider to adjust parameter of image.
Brightness
：
It indicates the total brightness of an image. As the value increases, the
image becomes brighter. It ranges from 0 to 100.
Contrast
：
It indicates the contrast between the bright part and the dark part of an
image. As the value increases, the contrast increases. It ranges from 0 to 100.
Sharpness
: it indicates the contrast between definition and edge sharpness. The higher
value, the higher definition and greater distortion. It ranges from 0 to 100
Step 3
Click
Save
, the message "Save succeed" is displayed, the system saves the settings.
----End
6.4
Scene
Figure 6-5 shows the
Scene
interface
