Email: [email protected]
Facebook: #SundayLiving
5
NOTE: Please feel free to contact Service Team for help if the remote
control is missing or damaged.
Facebook: #SundayLiving
Message: #SundayLiving
Email: [email protected]
PREPARATION
Place the heater on a firm, level surface and plug into a 120V 60Hz power outlet.
Caution: The rear of the heater should be at least 4 inch away from the wall.
Please pull the insulating film out of battery cover before using the remote control.
OPERATION INSTRUCTION
1.First turn on the Power switch on the right side of the heater. The Power switch supplies power to all the function
of the fireplace. This switch must be in
“
I
”
position for any functions including the remote control to work.
Press the Power button on the remote control, the heat and flame effect
will be on. Press the Power button again, heat and flame effect will be off
immediately (but the fan will prolong working for 30 seconds), and then
the heater goes into a standby mode.
PULL
Remote control
Insulating film
Battery cover
