Sundance Spas Claremont 980 Series, Руководство пользователя

Страница: 54 / 88

Page 48
980™ Series
12.5 Cleanup Cycle
The cleanup cycle occurs once per day at 12:00 PM (noon). This is
not user programmable. Turning off the corresponding jets pump that
is running can deactivate the feature. Jets Pump 1 and the Circulation
Pump turn on for 1 minute and then shut off. Then Jets Pump 2 turns on
for 1 minute and then shuts off. Then the blower turns on for 1 minute
and then shuts off.
12.6 Blow-Out Cycle
This cycle will purge the air from the plumbing lines normally caused by
draining and filling the spa. The Jets Pump 1 and the Circulation Pump
will turn on for 1 minute and then shut off. Then Jets Pump 2 will turn
on and run for 1 minute then shut off. Turning off the corresponding jets
pump that is running can deactivate the feature. This cycle will only
occur at start up and after exiting a service lock.
12.7 Water Care Programming
Water care is crucial to maintaining a healthy and clean spa. The
CLEAR RAY water purification system leads the way by sanitizing the
water using a UV light bulb. Your spa can be programmed to remind you
when to check and replace certain components.
From the Settings Menu, tap the
Water Care...
menu tab, Figures 12.7a and
12.7b. Then select one of the features to program by tapping or .
A. Programming the CLEARRAY UV Bulb Timer
The CLEAR RAY UV bulb has a life expectancy of 1 year. A timer
activates when power is applied and begins a countdown starting at
365 days. Once the timer expires, an error message will appear on the
display (page 71), the UV bulb must be replaced and the timer needs
to be reset.
Note:
• The days are stored in memory if the power is interrupted.
• The CLEAR RAY UV timer counts down by days not usage.
Figure 12.7a Figure 12.7b
6:45
Water Care
set to
Set
260 Days
ClearRAY®
365
Auto 6:45
SETTINGS
SunCooler ...
Auto
Time & Date...
SunSmart ...
TM
TM
Water Care...
Heat & Filter...