IMPORTANT PRODUCT INFORMATION READ IMMEDIATELY
KEEP ORIGINAL PACKAGING – ALL RETURNS NEED TO BE IN THE ORIGINAL PACKAGING
IN ORDER TO AVOID PRODUCT DAMAGE DURING SHIPPING. ANY DAMAGE TO PRODUCTS
NOT IN THEIR ORIGINAL PACKAGING WILL NOT BE COVERED UNDER WARRANTY.
SAFETY FIRST!
FAILURE TO OBSERVE THE FOLLOWING SAFETY WARNINGS MAY RESULT IN SERIOUS INJURY. IN ADDITION, FAILURE TO OBSERVE THESE
SAFETY WARNINGS WILL RESULT IN A WAIVER OF ALL LIABILITIES ON SUNLIGHT SUPPLY
®
, INC. AND WILL VOID ALL WARRANTIES.
WARNING:
• Disconnect power before re-lamping.
• When re-lamping, make sure lamp has time to cool before touching.
• Make sure power cord and lamp are connected properly.
• Do NOT hang by power cord or lamp cord.
• Do NOT make contact with the interior of the socket while the power is on.
• Do NOT operate the light systems in wet locations.
• Do NOT plug this system into a supply voltage other than what is instructed on the ballast.
• Do NOT attempt to open, rewire or reconfigure any components of the light system.
It will void the warranty and could cause serious injury or death.
• These products operate at very high temperatures. Keep away from children.
• Do not plug or unplug a power cord while the ballast is turned on.
• Read all warnings and instructions that come with your lamp
BULB INSTALLATION:
• Use gloves or cloth to avoid handling lamp with bare hands.
• The lamp base has pins with different shapes
(Fig. 1)
.
Line up the correct pins with the lamp-holder.
• Carefully press down and turn 30 - 45 degrees clockwise until lamp locks in.
The lamp-holder will give a snap-in sensation to confirm proper insertion of the lamp.
Proper Bulb Care
Always unplug your ballast and allow your lamp to cool before changing out your lamp. Lamps should be changed out after 20,000 hours to maintain maximum lumen
output. Running a lamp beyond its expected life is not recommended and can cause lamp failure as well as a shift in the color spectrum.
Note - Until the lamp has achieved at least 10 hours of operation, the lamp should never be turned off sooner than 2 minutes.
This Includes during installation tests. In cases when this has happened you need to wait 1 hour before switching the lamp on again.
NEUTRON
™
LEC
®
315 REFLECTOR #906268
Technical Information Guide
Fig. 1
lamp base
different pins
lamp-holder
