Sun Oracle SPARC T4-1B, Руководство по установке

Страница: 35 / 58

Powering On the Server Module for the First Time 29
a. Select the Remote Control tab on the top menu.
b. Click on Use serial redirection.
c. Click on Launch Remote Console.
This remote console will display host messages and prompts for installing the
Oracle Solaris OS when you power on the server module.
9. Power on the server module.
a. Select the Remote Power Control tab.
b. Click on the menu and select Power On.
c. Select Save.
d. Select OK when you see this prompt:
Are you sure you want to
perform a Power On of the server
.
The server module host is powered on for the first time.
10. You can now configure the Oracle Solaris OS to meet your needs.
See “Configuring the Oracle Solaris OS” on page 37 .
Related Information
■
“Plan Communication With the Server Module During Installation” on page 15
▼
Method 1b – Power On the Host
Through the CMM (CLI)
You connect to the CMM through the RJ-45 NET MGT 0 Ethernet port. While this
Ethernet connection supports both the CLI and the web interface to the CMM SP, this
procedure uses the CMM CLI.
1. Ascertain the IP addresses for the CMM.
2. Ensure that the CMM is connected to the network you are on.
The network connection is through the RJ-45 connector labeled NET MGT 0 on the
CMM.