Sun Microsystems Ultra 5, Руководство по обслуживанию

Страница: 48 / 258

2-2 Sun Ultra 5 Service Manual • February 2000
SunVTS executes multiple diagnostic tests from one graphical user interface (GUI)
that provides test configuration and status monitoring. The user interface can run in
the CDE or OPEN LOOK environments or through a TTY-mode interface for
situations when running a GUI is not possible.
The SunVTS interface can run on one system to display the SunVTS test session of
another system on the network.
SunVTS is distributed with each SPARC™ Solaris™ operating environment release.
It is located on the Sun Computer Systems Supplement CD.
2.1.1 SunVTS Requirements
Your system must meet the following requirements to run SunVTS:
■
The SunVTS packages must be installed. The main package is SUNWvts. There
are additional supporting packages that differ based on the version of the Solaris
operating environment that is installed. For specific details, refer to the
corresponding SunVTS documentation (described below).
■
The system must be booted to the multiuser level (level 3).
■
To run SunVTS with a GUI, that GUI must be installed. Otherwise, run SunVTS
with the TTY-mode interface.
2.1.2 SunVTS References
For more information about using SunVTS, refer to the SunVTS documentation that
corresponds to the Solaris software version that you are running.
The SunVTS documents are part of the Solaris on Sun Hardware AnswerBook
collection. This AnswerBook collection is preinstalled on the hard disk of new
systems. It is also distributed on the Software Supplement CD that is part of each
Solaris Media Kit release and is also accessible at http://docs.sun.com.
The following list describes the content of each SunVTS document:
■
SunVTS User’s Guide – describes how to install, configure, and run the SunVTS
diagnostic software.
■
SunVTS Quick Reference Card – provides an overview of how to use the SunVTS
CDE interface.
■
SunVTS Test Reference Manual – provides details about each individual SunVTS
test.